Motorola Solutions인증MSC-122시험은 IT인증시험과목중 가장 인기있는 시험입니다. ITExamDump에서는Motorola Solutions인증MSC-122시험에 대비한 공부가이드를 발췌하여 IT인사들의 시험공부 고민을 덜어드립니다. ITExamDump에서 발췌한 Motorola Solutions인증MSC-122덤프는 실제시험의 모든 범위를 커버하고 있고 모든 시험유형이 포함되어 있어 시험준비 공부의 완벽한 선택입니다.
Motorola Solutions인증 MSC-122시험을 어떻게 공부하면 패스할수 있을지 고민중이시면 근심걱정 버리시고ITExamDump 의 Motorola Solutions인증 MSC-122덤프로 가보세요. 문항수가 적고 적중율이 높은 세련된Motorola Solutions인증 MSC-122시험준비 공부자료는ITExamDump제품이 최고입니다.
Motorola Solutions인증MSC-122시험에 도전해보려고 없는 시간도 짜내고 거금을 들여 학원을 선택하셨나요? 사실 IT인증시험은 보다 간단한 공부방식으로 준비하시면 시간도 돈도 정력도 적게 들일수 있습니다. 그 방법은 바로ITExamDump의Motorola Solutions인증MSC-122시험준비덤프자료를 구매하여 공부하는 것입니다. 문항수도 적고 시험예상문제만 톡톡 집어 정리된 덤프라 시험합격이 한결 쉬워집니다.
ITExamDump 의 Motorola Solutions인증 MSC-122덤프는 PDF버전과 소프트웨어버전 두가지 버전으로 되어있는데 소프트웨어버전은 시뮬레이션버전입니다. 소프트웨어버전의 문제를 푸는 과정은 시험현장을 연상케하여 시험환경에 먼저 적응하여 실제시험에서 높은 점수를 받도록 도와드릴수 있습니다.
시험 번호/코드: MSC-122
시험 이름: Motorola Solutions (Deploy WLAN Solutions)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 113 문항
업데이트: 2014-01-19
MSC-122 덤프무료샘플다운로드하기: http://www.itexamdump.com/MSC-122.html
NO.1 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B
Motorola Solutions MSC-122 MSC-122
NO.2 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D
Motorola Solutions dump MSC-122 MSC-122
NO.3 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B
Motorola Solutions MSC-122기출문제 MSC-122 pdf
NO.4 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A
Motorola Solutions dumps MSC-122기출문제 MSC-122 pdf MSC-122 MSC-122
NO.5 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A
Motorola Solutions인증 MSC-122 MSC-122 MSC-122
NO.6 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D
Motorola Solutions최신덤프 MSC-122 MSC-122 MSC-122인증 MSC-122 dump
NO.7 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A
Motorola Solutions MSC-122 MSC-122 MSC-122 MSC-122
NO.8 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D
Motorola Solutions시험문제 MSC-122 MSC-122최신덤프
NO.9 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A
Motorola Solutions MSC-122 MSC-122 MSC-122
NO.10 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C
Motorola Solutions덤프 MSC-122덤프 MSC-122 MSC-122 pdf
NO.11 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C
Motorola Solutions MSC-122 dump MSC-122 MSC-122 MSC-122덤프
NO.12 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A
Motorola Solutions MSC-122 MSC-122시험문제 MSC-122시험문제 MSC-122
NO.13 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B
Motorola Solutions자격증 MSC-122인증 MSC-122 MSC-122
NO.14 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C
Motorola Solutions MSC-122 MSC-122덤프 MSC-122기출문제 MSC-122 pdf
NO.15 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C
Motorola Solutions MSC-122 MSC-122 dump MSC-122
ITexamdump의 000-619덤프의 VCE테스트프로그램과 700-104덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 HP0-J67시험에 대비한 고품질 덤프와 000-503시험 최신버전덤프를 제공해드립니다. 최고품질 000-959시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기