HP HP0-Y36 최신덤프

ITExamDump의 HP인증HP0-Y36시험대비덤프는 실제시험문제 출제경향을 충분히 연구하여 제작한 완벽한 결과물입니다.실제시험문제가 바뀌면 덤프를 제일 빠른 시일내에 업데이트하도록 하기에 한번 구매하시면 1년동안 항상 가장 최신의HP인증HP0-Y36시험덤프자료를 제공받을수 있습니다.

다른 사이트에서도HP HP0-Y36인증시험관련 자료를 보셨다고 믿습니다.하지만 우리 ITExamDump의 자료는 차원이 다른 완벽한 자료입니다.100%통과 율은 물론ITExamDump을 선택으로 여러분의 직장생활에 더 낳은 개변을 가져다 드리며 ,또한ITExamDump를 선택으로 여러분은 이미 충분한 시험준비를 하였습니다.우리는 여러분이 한번에 통과하게 도와주고 또 일년무료 업데이트서비스도 드립니다.

시험 번호/코드: HP0-Y36
시험 이름: HP (Deploying HP Enterprise Networks)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 73 문항
업데이트: 2014-03-11

여러분은 우리. ITExamDump의HP HP0-Y36시험자료 즉 덤프의 문제와 답만 있으시면HP HP0-Y36인증시험을 아주 간단하게 패스하실 수 있습니다.그리고 관련 업계에서 여러분의 지위상승은 자연적 이로 이루어집니다. ITExamDump의 덤프를 장바구니에 넣으세요. 그리고 ITExamDump에서는 무료로 24시간 온라인상담이 있습니다.

우선 우리ITExamDump 사이트에서HP HP0-Y36관련자료의 일부 문제와 답 등 샘플을 제공함으로 여러분은 무료로 다운받아 체험해보실 수 있습니다.체험 후 우리의ITExamDump에 신뢰감을 느끼게 됩니다. ITExamDump에서 제공하는HP HP0-Y36덤프로 시험 준비하시면 편안하게 시험을 패스하실 수 있습니다.

HP0-Y36 덤프무료샘플다운로드하기: http://www.itexamdump.com/HP0-Y36.html

NO.1 Which characteristics of a Circuit Cross Connect (CCC) L2VPN distinguish it from the Martini or
Kompella versions? (Select two.)
A. It requires a stack of three MPLS labels.
B. It includes exactly two endpoints of the VPN.
C. It can operate with fewer than two MPLS labels.
D. It does not require any Label signaling.
Answer: C,D

HP자료   HP0-Y36최신덤프   HP0-Y36

NO.2 Which parameters must be configured on two PE routers to provision an Ethernet L2VPN in Martini
mode? (Select four.)
A. PW-ID
B. LDP Remote Peer
C. VPN Instance
D. Service Instance
E. S-VID
F. L2VPN Address Family
G. Route Distinguisher
H. IP Binding
Answer: A,B,D,E

HP   HP0-Y36   HP0-Y36 dumps

NO.3 Which technology in an MPLS L2VPN can provide ordered delivery of Ethernet frames?
A. TCP-based L2VPN
B. Control Word
C. Ethernet raw access circuit
D. VLAN pseudowire class
E. MPLS EXP bits
Answer: B

HP   HP0-Y36덤프   HP0-Y36   HP0-Y36 dump   HP0-Y36

NO.4 Click the Exhibit button.
A provider of MPLS services configures MPLS Layer-3 VPN services for two customers. Each customer
has three branch offices that will be interconnected. The address blocks chosen by the customers for
each site are:
The provider uses OSPF as its IGP with the Loopback 0 addresses shown as the OSPF router-id and the
MPLS LSR-ID. Customer A Site 1 successfully pings Customer A Site 2. This ICMP echo request is
captured on the Ethernet segment between routers P-10 and P-20. What is found on this packet capture?
(Select two.)
A. MPLS VPN label
B. VPN target
C. MPLS outer label corresponding to the LSR-ID of P-20
D. MPLS outer label corresponding to FEC 16.0.0.2
E. route distinguisher
Answer: A,D

HP dumps   HP0-Y36   HP0-Y36최신덤프   HP0-Y36시험문제

NO.5 What can be included in BGP or multi-protocol BGP Network Layer Reachability Information (NLRI)?
(Select three.)
A. AS 65001
B. 10.0.0.0 /9
C. MED
D. Remote LDP Session
E. BGP ORF
F. VPN Target
G. VPLS Label Block
H. 6500:301:192.168.0.0 /16
Answer: B,G,H

HP자격증   HP0-Y36   HP0-Y36 pdf   HP0-Y36

NO.6 In the configuration of a Martini version L2VPN on two PE routers, which parameter must be identical?
A. S-VID
B. PW-ID
C. VLAN-ID
D. Service Instance number
E. VPN-Target
F. Remote LDP Peer IP address
Answer: B

HP자격증   HP0-Y36자격증   HP0-Y36

NO.7 Click the Exhibit button.
A provider of MPLS services configures MPLS Layer-3 VPN services for two customers. Each customer
has three branch offices that will be interconnected. The address blocks chosen by the customers for
each site are:
The provider has established only four Multi-Protocol BGP peers as shown in the exhibit. PE-4 has no
customer connections. Neither MPLS L3VPN is functional. Which configuration steps are required if this
topology is to be operational for both customers.? (Select two.)
A. Create VPN instances Customer A and Customer B on PE-4.
B. Configure PE-4 as a route-reflector within the bgp l3vpn-family.
C. Configure PE-4 as a route-reflector within the ipv4-family vpnv4.
D. Configure PE-4 as a route-reflector within the ipv4-family vpn-instance Cust-A and vpn-instance
Customer B.
E. Configure PE-4 as a bgp route-reflector.
F. Configure MBGP peers for P-10, P-20, and P-30.
Answer: A,C

HP   HP0-Y36 pdf   HP0-Y36덤프   HP0-Y36인증   HP0-Y36자격증

NO.8 Click the Exhibit button.
A provider of MPLS services offers multiple types of MPLS-based VPNs to its customers. Provider Edge
router PE-1 directly connects to the following three customers:
What is the minimum number of LDP peers established on Router PE-1?
A. 1
B. 2
C. 3
D. 4
E. 5
Answer: B

HP   HP0-Y36   HP0-Y36 dumps

NO.9 Click the Exhibit button.
Router-1 and Router-2 are BGP peers. Router-2 and Router-3 are BGP peers. However, Router-3 has not
learned the 16.0.0.0/8 BGP route. How can you resolve this issue? (Select two.)
A. Enable IGP synchronization on all routers.
B. Prepend AS1 to the 16.0.0.0/8 route on Router-1.
C. Enable BGP peering between Router-1 and Router-3.
D. Adjust the local preference of 16.0.0.0/8 on Router-1.
E. Configure Router-2 as a route reflector and Router-1 and Router-3 as clients.
F. Establish a physical link between Router-1 and Router-3.
Answer: C,E

HP   HP0-Y36   HP0-Y36 dumps   HP0-Y36최신덤프   HP0-Y36기출문제   HP0-Y36

NO.10 Which BGP attributes must be present in a BGP routing update? (Select three.)
A. community
B. MED
C. origin type
D. local preference
E. AS path
F. next hop
Answer: C,E,F

HP   HP0-Y36최신덤프   HP0-Y36   HP0-Y36 pdf

ITexamdump의 000-052덤프의 VCE테스트프로그램과 HP2-B111덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 70-464시험에 대비한 고품질 덤프와 E20-891시험 최신버전덤프를 제공해드립니다. 최고품질 JN0-380시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.

시험자료링크: http://www.itexamdump.com/HP0-Y36.html